Gasboy Tag Reader Bedienungsanleitung

MDE-4816A GGi

Tag Reader Installation Guide 6 1-3.1-3. FUNCTIONAL DESCRIPTION FUNCTIONAL DESCRIPTION1-3.1. Main Features The TR is based on advanced technol

1-3.2.2. Magnetic Stripe Fuel Cards If the TR is equipped with an optional magnetic card reader, at the right-hand side of the unit, the driver can

Tag Reader Installation Guide 8 Figure 1-3 Tag Reader. Power and Communication Cable The same interface can be used for maintenance purposes

Tag Reader Installation Guide 9In North America, use a NEC Class 2 power supply, low voltage and low current [maximum 100 VA even under fault con

Tag Reader Installation Guide 10  Operating current - 0.5 A Figure 1-4. Tag Reader – Dimensions 1-6.5. Environmental  Operating temp

Tag Reader Installation Guide 111-8.1-8. STANDARDS STANDARDS1-8.1. Communication Standard The Tag Reader communicates, in its different models,

Tag Reader Installation Guide 12 1-10.1-10. USING THIS MANUAL USING THIS MANUALThis manual includes alerting comments inserted along the docu

Tag Reader Installation Guide 130 SECTION 2 INSECTION 2INSTALLATION STALLATION2-1.2-1. GENERAL GENERALThis section provides installati

Tag Reader Installation Guide 14 2-2.2-2. TOOLS AND ACCESSORIES TOOLS AND ACCESSORIESTag Reader can be provided with an installation kit fo

Tag Reader Installation Guide 151. Above 18” (0.5 meter) from the island floor 2. At least 18” (0.5 meter) away from the dispenser Figure 2-2

Figure 2-3. Tag Reader Installation Holes, Internal View 2-5.2. General Instructions The following paragraph provides step by step instructions for

Tag Reader Installation Guide 176. Install the Tag Reader with support flange to the installation site: Smooth flat surface/Pole/ Dedicated Pole

1. Remove appropriate length of cable coating for connection to power supply and RS-485 ports 2. Connect the Tag Reader power wires to a 12-24 VDC

Tag Reader Installation Guide 192-5.5.2-5.5. Post-Installation Checks and Programming of Tag Reader Address Post-Installation Checks and

Figure 2-7. Scan/Set New Address Dialog Box d. Enter the address range to be scanned using the Scan From and To spin boxes and then click on the Sc

Tag Reader Installation Guide 210 SECTION 3 USSECTION 3USING TAG READER ING TAG READER3-1.3-1. GENERAL GENERALThis section provides

3. The two Tag Reader indicators, green  and red , flash for a few seconds to indicate that it reads the tag/card, a beep is heard, and the custome

Tag Reader Installation Guide 230 SECTION 4 MASECTION 4MAINTENANCE INTENANCE4-1.4-1. GENERAL GENERALThis section provides general main

Tag Reader Installation Guide 24 4-3.4-3. TROUBLESHOOTING TROUBLESHOOTINGTable 4-1 lists the recommended procedures for troubleshooting the Ta

SAFETY CONSIDERATIONS Read all warning notes and instructions carefully. They are included to help you installing the Product safely in the highly fl

CAUTION Do not attempt to make any repair on the printed circuit boards residing in the Product, as this will void all warranties related to this

TABLE OF CONTENTS Paragraph PageSECTION 1 GENERAL DESCRIPTION 1-1. SCOPE...

Tag Reader Installation Guide ii TABLE OF CONTENTS Paragraph Page2-2. TOOLS AND ACCESSORIES ...

Tag Reader Installation Guide iii LIST OF ILLUSTRATIONS Figure PageFigure 1-1. Tag Reader, General view ...

Tag Reader Installation Guide 4 0 SECTION 1 GESECTION 1GENERAL DESCRIPTION NERAL DESCRIPTION1-1.1-1. SCOPE SCOPEThis manual is provid

Two LEDs on the Tag Reader front panel indicate the transaction status: Green –  - Positive recognition, transaction was authorized Red –  - Nega